It’s for bias to the mic. Condenser mics need it to apply bias to one of the leads of the mic so it can amplify the sound before sending it to the input of the card. Some mics don’t require that (self-biased) so in that case, the R pin (middle ring) goes to GND.
Ah, seems you’re right. I didn’t know that. But that seems to be an old way of doing it. I’ve only ever seen 2 contacts on a seperate microphone jack or the 4-contact combined ones in modern laptops.
Regardless, if it doesn’t require the bias pin, the mic is self-biased or biased through another source (use the same wire for the signal to get bias, this is easy, you just use a cap to decouple the signal from the bias).
You are not logged in. However you can subscribe from another Fediverse account, for example Lemmy or Mastodon. To do this, paste the following into the search field of your instance: !technology@beehaw.org
A nice place to discuss rumors, happenings, innovations, and challenges in the technology sphere. We also welcome discussions on the intersections of technology and society. If it’s technological news or discussion of technology, it probably belongs here.
Remember the overriding ethos on Beehaw: Be(e) Nice. Each user you encounter here is a person, and should be treated with kindness (even if they’re wrong, or use a Linux distro you don’t like). Personal attacks will not be tolerated.
It’s for bias to the mic. Condenser mics need it to apply bias to one of the leads of the mic so it can amplify the sound before sending it to the input of the card. Some mics don’t require that (self-biased) so in that case, the R pin (middle ring) goes to GND.
Ah, seems you’re right. I didn’t know that. But that seems to be an old way of doing it. I’ve only ever seen 2 contacts on a seperate microphone jack or the 4-contact combined ones in modern laptops.
http://tuxgraphics.org/npa/condenser-mic-on-usb-sound-card/
The link doesn’t open, says connection refused 🤷.
Regardless, if it doesn’t require the bias pin, the mic is self-biased or biased through another source (use the same wire for the signal to get bias, this is easy, you just use a cap to decouple the signal from the bias).