will also see it sold as “magnet wire” (for winding your own electromagnets) and the heat from your soldering iron is usually enough to melt through the enamel varnish
That’s generally not recommended as a way of stripping them though, since the coating is often made of polyurethanes, which release alkyl isocyanates (highly toxic) when heated strongly. While a small amount in a well-ventilated area might not be enough to give you any problems, if you get too much it is very bad. The organic material will also impact the ability to solder. Better to scrape it off first.
You are not logged in. However you can subscribe from another Fediverse account, for example Lemmy or Mastodon. To do this, paste the following into the search field of your instance: !technology@beehaw.org
A nice place to discuss rumors, happenings, innovations, and challenges in the technology sphere. We also welcome discussions on the intersections of technology and society. If it’s technological news or discussion of technology, it probably belongs here.
Remember the overriding ethos on Beehaw: Be(e) Nice. Each user you encounter here is a person, and should be treated with kindness (even if they’re wrong, or use a Linux distro you don’t like). Personal attacks will not be tolerated.
will also see it sold as “magnet wire” (for winding your own electromagnets) and the heat from your soldering iron is usually enough to melt through the enamel varnish
That’s generally not recommended as a way of stripping them though, since the coating is often made of polyurethanes, which release alkyl isocyanates (highly toxic) when heated strongly. While a small amount in a well-ventilated area might not be enough to give you any problems, if you get too much it is very bad. The organic material will also impact the ability to solder. Better to scrape it off first.