In case you’re out of the loop, the old Steam Deck had Philips screws that screwed into self-tapping plastic holes. This lead to occasional stripped threads and often stripped screwheads.
Valve absolutely did not have to change their screws, and its probably actually against their best interests. While other companies around the world are constantly in search of new ways to screw their own consumers, Valve goes out of their way to update their screws to make them easier to install/remove by changing to torx screws and added metal threads in the backplate. Those who know anything about mechanical engineering know this is not an insignificant amount of effort they put into it.
This is a small change that makes a huge impact, and speaks volumes about the ethos of the company. It says:
We want to make our devices last longer, and be easier to repair.
If you want to buy the cheaper tier and save yourself a few bucks by installing whatever SSD you want, go right ahead.
We trust you to make decisions for yourself.
Most importantly, we respect you, the consumer, and want you to fully own and control the devices we sell.
Valve is by no means perfect, and there’s plenty more they could be doing, but they’ve earned my respect and my patronage and I won’t buy games from anywhere else. I will buy whatever future products they sell, even if I don’t think I’ll use them regularly.
Didn’t they change to torx and change the base they screw into metal?
The former is a mild annoyance, but they’re a pretty standard bit now that anyone that does any electronic DIY has in their set. The latter is a huge improvement.
Must admit I didn’t look too much into it though
but mostly seems positive.
Aha, OK. That’s my bad. When I read it on the phone earlier, I read the four point list as something you thought they should be doing, and not what they were doing. As such, I thought you were ranting against them.
You are not logged in. However you can subscribe from another Fediverse account, for example Lemmy or Mastodon. To do this, paste the following into the search field of your instance: !gaming@beehaw.org
From video gaming to card games and stuff in between, if it’s gaming you can probably discuss it here!
Please Note: Gaming memes are permitted to be posted on Meme Mondays, but will otherwise be removed in an effort to allow other discussions to take place.
Didn’t they change to torx and change the base they screw into metal?
The former is a mild annoyance, but they’re a pretty standard bit now that anyone that does any electronic DIY has in their set. The latter is a huge improvement.
Must admit I didn’t look too much into it though
but mostly seems positive.
Torx is the king of screws, change my mind :D
What is the advantage of torx over Phillips?
You strip them was less easily. Also, better grip on the screw=more torque
Good to know. I’m converted
I prefer the Arthur head screw.
Yes that’s what I said
Aha, OK. That’s my bad. When I read it on the phone earlier, I read the four point list as something you thought they should be doing, and not what they were doing. As such, I thought you were ranting against them.